Ford and Volkswagen MPV Forums

Large MPVs -- Ford Galaxy / VW Sharan / SEAT Alhambra: => Ford Galaxy / VW Sharan / SEAT Alhambra => Topic started by: I MAC on October 30, 2016, 11:37:01 AM

Title: Cabin fuse panel wiring diagram
Post by: I MAC on October 30, 2016, 11:37:01 AM
As title need a wiring diagram of the panel can't find the earth fault I have going to rear light clusters
And because of this can't get the indicators working on my folding camper
Specifically the 2 multi plugs in the middle of the fuse panel
Cheers for any help

Sent from my D6603 using Tapatalk

Title: Re: Cabin fuse panel wiring diagram
Post by: johnnyroper on October 30, 2016, 01:07:50 PM
Could try the vw Erwin website not sure if or how much it costs but all drawings etc are on there.
Title: Re: Cabin fuse panel wiring diagram
Post by: I MAC on October 30, 2016, 01:22:03 PM
Cheers will have a look after work

Sent from my D6603 using Tapatalk

Title: Re: Cabin fuse panel wiring diagram
Post by: Chrispb on October 31, 2016, 12:10:45 AM
Have you thought about using a bypass relay instead, been using one for over ten years without any problems.
Title: Re: Cabin fuse panel wiring diagram
Post by: I MAC on November 01, 2016, 12:55:08 AM
Did consider this but the point of the kit was so I didn't have to chop wires and could be removed if needed
But it is an option it's just if it works as it is the cars own wiring that has the earth faults even though everything works on the car fine

Sent from my D6603 using Tapatalk

Title: Re: Cabin fuse panel wiring diagram
Post by: Chrispb on November 01, 2016, 12:23:58 PM
You can get away with using scotch locks inside the car, that way you can easily remove the extra relay wiring without chopping right through.
The scotch locks make a small cut through the insulation, if you remove them later use insulating tape to cover the cut in the loom.
Title: Re: Cabin fuse panel wiring diagram
Post by: I MAC on November 01, 2016, 08:55:30 PM
As I have a plug in system will I not need to get a generic wiring kit instead

Sent from my D6603 using Tapatalk