Ford and Volkswagen MPV Forums

Large MPVs -- Ford Galaxy / VW Sharan / SEAT Alhambra: => Mk3 Ford Galaxy / Ford S-Max => Topic started by: DavidRichards1983 on January 01, 2018, 09:13:52 PM

Title: Programming a 2014 Mk3 Galaxy remote key /
Post by: DavidRichards1983 on January 01, 2018, 09:13:52 PM
You can tell its the start of the year and one my resolutions is to fix all the little buggy things that I've been putting off for ages.

Can someone guide me through the process of recoding or relearning / teaching the keyfob on my Galaxy as the remote section stopped working some time ago. I've replaced the batteries in the fob so now its just a question of getting the keyfob to talk to the car again for the remote locking to work.

TIA!
Title: Re: Programming a 2014 Mk3 Galaxy remote key /
Post by: Mirez on January 02, 2018, 10:52:55 AM
Hey David, the instuctions you are looking for are already in the ref library > Link (https://www.fordmpv.com/smf2/mk3-ford-galaxy-smax-common-faults-and-problems/ford-galaxy-mk3-remote-key-fob-programming-instructions/)

Copied here for you though:

1. Fasten the safety belts and close all doors to make sure that conflicting chimes do not sound during programming.
2. Turn the ignition switch from position I to position II four times within six seconds.
3. Turn the ignition switch to position I. An audible chime will be heard to indicate that learning mode is enabled.
4. Press and hold one of the buttons on the remote transmitter until a chime sounds. This indicates the remote transmitter code has been successfully received.
5. Repeat step 4, within 10 seconds, for any other transmitters you have.
6. Wait 10 seconds or turn the ignition switch to position II to exit learning mode.
7. Test all the programmed remote transmitters, by activating and deactivating the locking/unlocking functions.